Filter
Top Products
Listening to your system
05
42
En
Using the multichannel analog inputs
If you’ve connected to the multichannel inputs on the
rear panel (see
Connecting the multichannel analog
outputs
on page 20), you will be able to select them as
your input source.
1 Make sure you have set the playback source to
the proper output setting.
For example, you might need to set your DVD player to
output multichannel analog audio.
2 Press MULTI CH INPUT (MULTI CH IN on the front
panel) to select the multichannel analog inputs.
MULTI CH IN
shows in the display to indicate the audio
is coming from the multichannel analog inputs,
regardless of the input source selected. The input source
remains dedicated to the multichannel inputs until you
press
MULTI CH IN
/
MULTI CH INPUT
again to cancel.
• If you need to set the channel levels, see
Channel
Level
on page 56 to do so.
Note
• You can’t use any signal processing features (for
example, the
MOVIE
or
MUSIC
modes or the tone
controls) with the multichannel analog inputs.
• Any speakers set to
NO
in the
Speaker Setting
on
page 55 do not output the audio for the
corresponding channel.
• You can’t use the Second Zone speaker B setup
(page 71) with the multichannel analog inputs.
Listening with Acoustic Calibration
EQ
You can listen to sources using the Acoustic Calibration
Equalization set in
Automatically setting up for surround
sound
on page 12 or
Acoustic Calibration EQ
on page 88.
Refer to these pages for more on Acoustic Calibration
Equalization.
• While listening to a source, press ACOUSTIC EQ.
Press repeatedly to select between:
•
ALL CH ADJUST
– No special weighting is given to
any one channel.
•
FRONT ALIGN
– All speakers are heard in
accordance with the front speaker settings.
•
CUSTOM 1/2
– Custom settings
•
OFF
– Switches Acoustic Calibration EQ off.
The MCACC indicator on the front panel lights when
Acoustic Calibration EQ is active.
Note
• You can’t use Acoustic Calibration EQ when
MULTI
CH IN
or
SACD DIRECT
is switched on.
• If you switch on Acoustic Calibration EQ when
DIRECT
is selected, the receiver automatically
switches to
STEREO
.
MULTI DH
INPUT
ACOUSTIC
EQ
VSX-AX5Ai.book 42 ページ ２００４年６月２日 水曜日 午後３時２７分