Filter
Top Products
Listening to your system
05
43
En
Selecting the input signal type
Most of the audio inputs have both analog and digital
jacks. You can select the type of signal to be used in each
case.
The input signal type for the current input is indicated in
the display. With digital signals, the signal type (Dolby
Digital or DTS) also shows in the display.
The default
AUTO
setting is usually sufficient, letting the
receiver decide the most suitable signal type. However, in
other cases (for example, if you want to record the analog
output of a digital source) then you should set the input
signal type to analog.
1 Press RECEIVER.
2 Press SIGNAL SEL to select the type of input
signal for the current source.
Press repeatedly to choose between:
•
AUTO
– The receiver selects the first available signal
in the following order: ;
DIGITAL
;
ANALOG
.
•
ANALOG
– Selects an analog signal.
•
DIGITAL
– Selects an optical or coaxial digital signal.
Note
• If no digital inputs are assigned for the current
source, the input signal type is fixed to
ANALOG
.
• When using
DIGITAL IN
terminals the following
digital signal formats are supported: Dolby Digital,
DTS and PCM (32, 44.1, 48, 88.2 and 96 kHz sampling
frequencies). If you are using the i.LINK connectors,
DVD-A (including 192 kHz) and SACD are also
supported. If your source is not supported, select
ANALOG
.
• Some DVD players don’t output DTS signals. For
more details, refer to the instruction manual supplied
with your DVD player.
• The audio signal from karaoke microphones and
some LDs is not output from the digital outputs.
Select
ANALOG
to listen to these formats.
• If you want to play DTS-encoded sources, you need to
have digital connections. If
ANALOG
is selected,
you’ll hear digital noise through your speakers.
• The input signal for unassigned i.LINK-equipped
components is fixed to
DIGITAL
. See
Assigning the
i.LINK inputs
on page 82.
SIGNAL SEL
RECEIVER
VSX-AX5Ai.book 43 ページ ２００４年６月２日 水曜日 午後３時２７分