Filter
Top Products
49
OPERATION
4 Press the MULTI CONTROL button for the
component you want to control.
The selected button lights steadily and the first manufacturer
(and preset code(s)) appear on your TV screen.
5 Press the 2/3 buttons to choose the function and
then press the 5¥∞ buttons repeatedly to display
the name of the component's manufacturer.
Most manufacturers have been programmed into the receiver,
but if your component is made by a small or relatively unknown
manufacturer you may not be able to find it.
6 Point the remote toward the component to be
controlled, enter the 3 digit setup code.
When you enter the setup code, the remote emits a power ON/
OFF signal. If the component turns ON or OFF, you have entered
the proper code.
If the component does not turn ON or OFF and there is more
than one setup code, try inputting another code (starting again
from step 4). Some manufacturers use several sets of remote
control signals and the first code may not correspond to your
component.
Repeat steps 4 through 6 to assign preset codes for as many
components as necessary.
If you can't get your component to respond to any of the codes
you can still program the component into the remote control
using the procedure in the next section.
7 Press REMOTE SETUP to exit the PRESET RECALL
SETUP mode.
The remote control and TV return to their previous operation
modes.
Remote Control of Other Components
Preset Recall
1Select function
2Select products [5∞23]
3Input ID CODE
2 [TAPE ] 3 Page 1/11
5 [SONY ] ∞
[ 801 806 ]
EXIT=Remote setup
7
4
5
S0URCE
DVD/LD TV/SAT
VCR1 VCR2
CD
TV VOL
TV FUNC
MENU
ENTER
STEREO
DSP
THX
/dts
MUTE
TV
VOLUME
MD/
TAPE1
TUNER
TVCONT
RECEIVER
MULTI
OPERATION
CLASS MPX DIRECT ACCESS
CHANNEL
STATION
DTV ON/OFF DTV MENU
TUNING
EXIT
DISC
GUIDE
+10
TV CONTROL
FUNCTION
ADVANCED
MIDNIGHT
STANDARD
DIGITAL MULTI PROCESSING AMPLIFIER
REMOTE CONTROL UNIT
REMOTE
SETUP
DIGITAL NR
EFFECT
/CH SEL
SYSTEM
SETUP
SIGNAL
SELECT
BAND
SYSTEM
OFF
1
23
4
56
7
89
0
ENTER
Î
¶
873
1¡4¢
+
-
+
-
+
-
MULTI CONTROL
6