Filter
Top Products
40
Switching ANALOG/DIGITAL Signal Input
This switch moves the input fed to the receiver between analog, digital and AC-3RF (VSX-27TX only) sources . You need
to take special care to switch to the appropriate input, when necessary. For example, the switch would have to be on
digital to use DOLBY DIGITAL or DTS surround sound but it would have to be on analog to record to the analog out
jacks on the receiver. On the VSX-27TX the default setting is AUTO (which chooses digital when all three are available
but goes with whatever is available if it is the only choice) . On the VSX-26/24TX the default setting is ANALOG.
1 Press SIGNAL SELECT on the remote control or
SIGNAL SELECT on the front panel to select the
input signal corresponding to the source
component.
Each press switches the signal in the order below:
2 When SIGNAL SELECT is set to DIGITAL, AC-3 lights
when a Dolby Digital signal is input, and DTS lights
when a DTS signal is input
• In the AUTO setting (VSX-27TX only), SIGNAL SELECT chooses the
signal in the following order: AC-3 RF, DIGITAL, ANALOG.
• If the Digital-In Select (see p.34) choices are set to OFF, the SIGNAL
SELECT will default to ANALOG.
• Because the audio from a karaoke microphone and LD recorded
with analog audio only is not output from the digital output, set
SIGNAL SELECT to “ANALOG”.
• This receiver can only play back Dolby Digital, PCM (32kHz, 44kHz,
48kHz, and 96kHz), and DTS digital signal formats. It cannot play
back digital signals other than these so for those kinds of formats
you'll have to play them back in an analog manner (making sure
your equipment is hooked up with analog connections and setting
the SIGNAL SELECT to "ANALOG").
• When an LD or CD with DTS is played back with the SIGNAL
SELECT set in “ANALOG,” digital noise caused by playing back the
DTS directly (with no decoding) is output. To prevent noise, you
need to make digital connections (See p. 10, 11) and set SIGNAL
SELECT to “DIGITAL” (VSX-27TX could also be set to "AUTO").
• Some DVD players don’t output DTS signals. For more details, refer
to the instruction manual supplied with your DVD player.
memo
SIGNAL SELECT
When a Dolby Digital
signal is input.
When a DTS signal is input.
SIGNAL
SELECT
DTS
SP
A
DIGITAL
SIGNAL
SELECT
AC-3
SP
A
DIGITAL
SIGNAL
SELECT
DTS
DIGITAL
SIGNAL
SELECT
AC-3
DIGITAL
= AUTO = ANALOG = DIGITAL = AC-3RF
ENTER
STEREO
DSP
THX
/dts
FUNCTION
ADVANCED
MIDNIGHT
STANDARD
DIGITAL MULTI PROCESSING AMPLIFIER
REMOTE CONTROL UNIT
REMOTE
SETUP
DIGITAL NR
SYSTEM
SETUP
SIGNAL
SELECT
SIGNAL
SELECT
Basic Playback
VSX-27TX
=ANALOG
DIGITAL+
VSX-26TX/24TX models
VSX-27TX model