Filter
Top Products
43
SET UP
OPERATION
Adjusting bass and treble (tone control)
Use BASS (–/+) or TREBLE (–/+) to adjust the low and high frequencies (the receiver must be in STEREO mode).
Press BASS (–/+) to adjust the low frequencies.
Press TREBLE (–/+) to adjust the high frequencies.
• The tone control can be adjusted in a range of ±6 dB.
• The tone control cannot be adjusted in STANDARD,
ADVANCED THEATER modes as well as DSP, THX,
EXTERNAL DECODER, DIRECT, and 96kHz settings.
Adjusting the brightness of the display (front panel only)
Use the FL DIMMER button to adjust the brightness of the fluorescent display (FL=fluorescent display).
Press FL DIMMER.
Four levels of brightness ranging from very dim to very bright can be
selected. Each press changes the brightness of the display. When
rotating through the options, the default brightness can also be
selected.
DIRECT
Please note: it is a feature of this unit that the fluorescent
display will be brighter for a few seconds after you choose
a function (like DVD/LD, CD, etc.) and then get softer. This
will still happen when you adjust the brightness but the
new setting will be the one the display softens to.
memo
dB
STEREO
SIGNAL
SELECT
ANALOG
SP
A
VOLUME
dB
STEREO
SIGNAL
SELECT
ANALOG
SP
A
VOLUME
TREBLE –/+
BASS –/+
memo
Basic Playback
FL DIMMER
VSX-24TX
VSX-27TX/26TX
VSX-27TX
Direct playback
FL DIMMER
VSX-27TX
Press DIRECT to put the receiver in DIRECT mode.
This mode will give you the most accurate reproduction of two
channels sources.
memo
• None of the tone controls or other sound modes can
be used.