Filter
Top Products
Controls and displays
03
27
En
Chapter 3
Controls and displays
Display
1 SIGNAL indicators (page 69)
Light to indicate the currently selected input signal.
AUTO lights when the amplifier is set to select the input
signal automatically.
2 Program format indicators
These change according to which channels are active in
Dolby, DTS, DVD-A and SACD sources.
LS, S and RS will light at the same time to indicate
6.1channel sources.
• L – Left front channel
• C – Center channel
• R – Right front channel
• LS – Left surround channel
• S – Surround channel (mono)
• RS – Right surround channel
• LFE – Low frequency effects channel
3 ((( )))
Lights when an LFE signal is being input.
4 Analog level indicators
OVER indicator
Lights when an analog input signal is too high,
risking distortion. Use the input attenuator to reduce
the level.
ATT indicator (page 70)
Lights when the input attenuator is on.
5 Character display
6 Digital format indicators
• – Lights when a Dolby Digital signal is
detected.
• – Lights when a DTS signal is detected.
• – Lights when one of the Home THX modes is
selected.
• – Lights during Surround EX matrix processing.
• – Lights when a decoding DTS-ES audio.
• – Lights during DTS-ES discrete processing.
• – Lights during DTS-ES matrix processing.
• – Lights during Dolby Pro Logic II and
Pro Logic IIx processing.
• – Lights during Neo:6 processing with 2-
channel sources.
• – Lights during two-channel
playback.
7 Speaker indicators
Light to indicate the current speaker system, A and/or B.
8 TAPE 2 (page 69)
Lights when the TAPE 2 monitor is switched on.
DIGITAL
PRO LOGIC
2ch
PLAYBACK
DISC MTRX
Neo :6
OVER ATT
RDS
RF ATT
SP
A
B
L
LFE
TAPE2
CR
L
S
SR
S
ENO
SIGNAL
AUTO
RF
DIGITAL
ANALOG
1 2 5 63 4
78
DIGITAL
DIS
C
MTR
X
PRO LOGIC
Neo :6
2ch
PLAYBAC
K