Filter
Top Products
Before you start
01
10
En
2 Use the + and – buttons to set the LCD TIMEOUT
and BACKLIGHT TIMEOUT settings.
You can adjust these from 20–120 seconds.
• The backlight timeout can’t be longer than the LCD
timeout setting.
3 Press ENTER when you’re finished.
You’ll return to the remote setup menu.
Resetting the remote control
Use this feature to reset the remote control settings to
the factory defaults.
Important
• Doing this will erase any of your personalized
settings.
1 Press RESET TO DEFAULT.
2 Confirm by pressing YES after reading each
screen.
After the screen goes blank, the Home menu appears
within a minute or so, and the remote control will be reset
to the default settings.
Locking the remote control
This amplifier has a remote control lock feature that
makes the remote control touch screen and hard keys
inoperative.
1 At the same time, press the and hard keys
for about three seconds.
• This is not possible from the remote setup screen.
LOCKED! shows on the touch screen to indicate the
remote control is locked.
2 To unlock the remote control, repeat step 1.
Once the remote control is unlocked, the touch screen
shows the Home menu.
Restarting the remote control
If the remote control display freezes during operation
(none of the buttons seem to work), you may need to
restart the unit.
Important
• Doing this will not erase any of your personalized
settings or presets.
1 Use a small phillips screwdriver to remove the
screw fixing the battery cover to the back of the
remote.
TIMEOUT
CANCELENTER
LCD TIME OUT
60 sec
60 sec
+
+
BACKLIGHT TIME OUT
-
-
SETUP 3/3
RESET TO DEFAULT
RESET
NO
YES
Do you want to reset
the REMOTE to the
DEFAULT settings ?
RESET
NO
YES
ALL settings you made
will be ERASED.
Is it all right?
AV AMPLIFIRE
MENU MUTE
CHANNEL VOLUME
SYSTEM
SETUP
ENTER