Filter
Top Products
8
Remote controller basics
Installing the batteries
1. Open the battery compartment, as
shown.
2. Insert the batteries (AA, R6, UM-3) as
shown, observing the correct polarity
(positive
+ and negative -).
3. Close the battery compartment, as
shown.
Always replace both batteries at the same
time. Never mix new and old batteries or
batteries of a different type.
If you do not intend to use the remote con-
troller for an extended period, remove the
batteries to prevent possible leakage and
corrosion.
Remove dead batteries immediately to pre-
vent possible leakage and corrosion.
If the remote controller doesn’t operate reli-
ably, replace both batteries.
The bundled batteries should last about six
months, although this varies with usage.
Using the remote controller
For reliable operation, point the remote con-
troller toward the CR-N1’s remote control
sensor, as shown.
Situate the CR-N1 away from strong light
sources, such as direct sunlight or
inverter-type florescent lights, which can
affect remote controller performance.
Using another remote controller of the same
type in the same room, or using the CR-N1
near equipment that uses infrared light may
affect remote controller performance.
Do not put items on top of the remote con-
troller that may inadvertently press the
remote controller’s buttons, thereby drain-
ing the batteries.
The remote controller will not work properly
if there’s an obstacle between it and the
CR-N1’s remote control sensor.
Remote control
sensor
About 5 m
(16 feet)