Filter
Top Products
41
Listening to the radio
You must connect the antenna in order to
use the radio. See “Connecting an AM
antenna” on page 23 and “Connecting an
FM antenna” on page 24 for information.
1 To select either FM or AM, press the
INPUT button on the CR-N1 repeatedly
until “FM” or “AM” appears on the dis-
play, or press the FM or AM button on
the remote controller.
2 For FM stations: press and hold a Tuning
( / ) button for more
than half a second and then release it.
The CR-N1 searches for the next station.
While the frequency value is still flash-
ing on the display, if necessary, use the
Tuning ( / ) buttons to
fine tune the station in small steps. The
Tuning ( ) indicator appears when a
station is properly tuned.
3 For AM stations: press and hold a Tuning
( / ) button for more
than half a second to start tuning, then
release when the desired frequency is
reached. While the frequency value is
still flashing on the display, use the Tun-
ing ( / ) buttons to fine
tune the station in small steps. The Tun-
ing ( ) indicator appears when a sta-
tion is properly tuned.
Note that once the frequency value stops
flashing, pressing the Tuning (
/
) buttons selects the presets, not
the frequency. In order to adjust the fre-
quency, you must press and hold the Tun-
ing ( / ) buttons for
more than half a second.
The Volume, Muting, and Acoustic Pres-
ence functions can all be used with the
radio.
INPUT
AM
FM
Tuning the radio
Remote controller
STEREO
MHz
kHz