Onkyo CR-N1 CD Player User Manual


 
59
Troubleshooting
Severe electrical interference may render the CR-N1s microcomputer temporarily inoperable.
In this case you should unplug the CR-N1 for at least ve seconds, and then reconnect it.
FM reception is hindered by
hiss and the tuning and stereo
indicators are ashing.
The received signal is too
weak?
Install an outdoor FM antenna. See
page 24.
Stereo FM transmissions travel
only half the distance of
regular transmissions?
Try changing the position and
direction of the outdoor antenna.
Set the FM mode to Mono. See
page 46.
The radio presets no longer
work.
The AC power cord has not
been connected to a wall
outlet for an extended
period?
The AC power cord must be plugged
into a wall outlet a few times each
month in order to preserve the radio
presets and other settings.
Reprogram the presets. See page 42.
RDS doesnt work.
The tuned station does not
support RDS?
Tune into an FM station that
supports RDS.
The signal is too weak?
Install an outdoor FM antenna. See
page 24.
Try changing the position and
direction of the outdoor FM
antenna.
Theres too much
interference?
Locate the FM antenna as far away
as possible from any uorescent
lights. See page 24.
Install an outdoor FM antenna. See
page 24.
CD playback skips.
The CR-N1 is exposed to
vibration?
Place the CR-N1 somewhere free
from vibration.
The disc is badly scratched? Replace with a new disc.
The disc is very dirty? Clean the disc.
Tracks cannot be memorized
with Memory Playback.
No disc is loaded? Load a disc. See page 35.
The CD doesnt contain the
track number you are trying
to memorize?
Memorize only available track
numbers.
A disc is loaded, but playback
cannot be started.
The disc is loaded the wrong
way round?
Load the disc with the labeled side
facing forwards. See page 35.
The disc is very dirty? Clean the disc.
Condensation has formed
inside the CR-N1?
Unload the disc and leave the CR-N1
for several hours until the
condensation has cleared.
It takes a long time to locate
specied tracks.
The disc is very dirty? Clean the disc.
The disc is scratched? Replace with a new disc.
USB setup has been
completed, but the new
device detected window
keeps appearing.
Windows has become
unstable.
Restart your PC.
Symptom Possible cause Remedy