Filter
Top Products
53
Troubleshooting
When in doubt !
Many issues can be resolved by powering the unit off and then back on again or by
resetting to factory default settings. Before proceeding to any other troubleshooting
procedure follow these steps:
1. Set power to OFF
2. Wait 10 seconds or until display completely blanks
3. Set power to RECEIVE or TRANSMIT
Reset to Default Factory Settings
1. Set power switch to OFF
2. Press and hold C key
3. Continue to hold C and set the power switch to either RECEIVE or TRANSMIT
4. Release C key when CLEAR/RESET message appears
Default factory settings are as follows:
Channel 17 Display Contrast Medium
Transmitter
Zones
A B C D L all
enabled
Delay Time 0.0100 sec
Receiver Zone A Equalize
Calculated Time
0.1500 sec
Relay Mode OFF Interval Time 100 sec
Operating mode NORMAL Multipop Time 1.00 sec
Contact Time 0.12 sec Counter Mode OFF
Beep Mode All Counter Load 36
Fast Mode OFF
N The following indicators may operate erratically during reset, but will return to
normal operation when reset completes: Battery Level, Frequency Lock, Beep Mode,
and Channel.
L The CLEAR/RESET message also displays the software version installed in the
unit. To view just the software version without losing settings refer to the Software
Version Display section, Page 40, for more information.