Filter
Top Products
17
Triggering Multiple Flashes With Multiple RECEIVE Units
Multiple remote flash units may be triggered in sync with each other.
1. Install batteries in each additional MultiMAX unit
2. Use flash cable to connect each additional flash unit’s sync terminal to
FLASH / PORT 2
3. Set power switch on each additional MultiMAX unit to RECEIVE mode
4. Set all MultiMAX units to same channel as TRANSMIT unit
You’re all set! Use the camera normally.
Connecting MultiMAX (set for TRANSMIT mode) to Flash
A flash can be connected to a MultiMAX (set for TRANSMIT mode). It will trigger in sync
with the remote flash units. This flash is called the local flash and is usually mounted
on a camera bracket.
1. Use a flash cable to connect the flash unit’s sync terminal to FLASH / PORT 2 of
the MultiMAX (set for TRANSMIT mode)
2. Use the L key to enable or disable the Local flash
You’re all set! Use the camera normally.
L Using a local flash this way protects the camera from high voltages. See the
Specifications section, Page 50, for more information.