Filter
Top Products
12
Power Switch
PORT 1 / PORT 2 / Status LED
Keypad
Controls
Power Switch
• TRANSMIT Unit is powered on in
TRANSMITTER (TX) mode
• RECEIVE Unit is powered on in
RECEIVER (RX) mode
• OFF Unit is powered OFF
Keypad
• A B C D L Selects Quad-Triggering Zones
and Local. Also used in menu
navigation and numeric entry
• TEST Triggers MultiMAX. Press to test
operation or to trigger remote units
and/or attached cameras/flashes
• (Back Light) Illuminates LCD and
keypad. Hold down for key lock
• ~/MENU Enters or exits menu system.
Stores numbers in numeric entry
• (Up / Down) Selects channels.
Also used in numeric entry
PORT 1 / PORT 2
• CAMERA / PORT 1 =
• Input from camera sync terminal,
external trigger button, Flash
Confirmation Cable, or other device
• Output to camera motor drive, flash, or
other device
• FLASH / PORT 2 =
• Output to flash, camera motor drive, or
other device
Status LED
Displays the following information:
• Blinking every few seconds = power on, ready for trigger
• Blinking in sync with trigger = normal triggering
• Steady =
• continuously triggered from radio, hot shoe, or PORT 1
• performing delay or contact time
• Slow blink every second = performing Intervalometer or Multi-pop function
• Dark = power off or poor battery condition