Filter
Top Products
ENGLISH
34
ERROR MESSAGES
Displayed Error Cause How to Remedy
MIC SET ERROR!!
AUTO SETUP
AUTO SETUP: START
MAIN ROOM
SURR BACK: 2CH
MIC SET ERROR!!
RETURN EXIT
• The microphone is not properly connected. • Connect the included microphone.
• Check the microphone connection.
NOISE ERROR!!
AUTO SETUP
SPEAKERS CHECK:
NOISE ERROR !!
RETURN EXIT
• There is too much noise in the listening room to measure properly.
• Volume from the speakers is low.
• During measurement, turn off devices that make noise such as air
conditioners.
• Measure at a time when the surrounding area is quiet.
ANALYZE ERROR!!
AUTO SETUP
SPEAKERS CHECK:
ANALYZE ERROR !!
RETURN NEXT EXIT
* Under ANALYZE ERROR, select “NEXT” with the 3/4 cursor
buttons and press the ENTER button. A detail screen like the
following appears on the display.
SPEAKER CONFIG
CHECK !! SPEAKER
FRONT L : YES REV
CENTER : NON
FRONT R : YES REV
SURR.R : NON ERR
SURR.B R : YES ERR
SURR.B L : YES ERR
SURR.L : NON ERR
SUB W : YES
RETURN EXIT
• The speakers required for suitable playback were not detected.
• Speaker polarity is connected backwards.
In the examples at left, the following trouble is detected.
• The polarity of the left and right channels of the front speakers is
backwards ([REV] appears on the display.)
• The surround speaker is not connected ([NON] is displayed), but
the surround back speaker is connected
(In this kind of situation, [ERR] is displayed for all surround and
surround back speakers.)
An error is indicated in addition to the above if the speakers are
connected as follows.
• When using just one surround back speaker, but it is connected to
the surround back R-channel
(To use just one surround back speaker, connect it to the L-
channel.)
• Check the speaker that is indicated as having reversed polarity
([REV] can appear with some speakers even when properly
connected. In such case, ignore the error indication.)
• Check speaker direction and layout