ENGLISH
19
HDMI JACK
This SR6001 has two HDMI inputs and one HDMI
output. The unit can send digital video and audio
signals from DVDs and other sources directly to a
display. It minimizes signal degradation caused by
analog conversion so that high quality images can
be enjoyed.
The SR6001 is also capable of converting analog
video signals (Composite Video, S-Video, Component
Video) for HDMI output.
Select an input source from the OSD menu system.
(See page 29, 40)
Notes:
• When the HDMI output is connected to a display
monitor that does not support HDCP, signals are not
output. To view images in HDMI, it is necessary to
connect to a display that supports HDCP.
• There may be no image output if connected to a
TV or display that is not compatible with the above
format.
• Refer to the instruction manual of the TV or display to
be connected to the SR6001 for detailed information
regarding the HDMI terminal.
* HDCP: High-bandwidth Digital Content Protection
CONNECTING HDMI DEVICES
An HDMI cable (sold separately) is used to connect the
HDMI jack on the SR6001 with the HDMI jack on a DVD
player, TV, projector or other component. To transmit
multichannel audio via HDMI, the connected player
must support multichannel audio transmission through
its HDMI jack.
HDMI video streaming is compatible with DVI in
principle. Therefore, it is possible to connect to a TV
or monitor that has a DVI terminal using an HDMI-DVI
conversion cable or plug. When connecting to a DVI
terminal, connect the audio signal separately.
Notes:
• Some HDMI components can be controlled over the
HDMI cable, but this receiver cannot control other
components this way.
• When connected to a monitor (i.e., TV, projector,
etc.) that does not support HDCP, video and audio
are not output.
• DVI cables come with 24-pin and 29-pin plugs. This
receiver supports 24-pin DVI-D cables; 29-pin DVI
cables cannot connect to it.
• Some source devices such as DVD players or set
top box do not support HDMI repeater operations
like those of the SR6001. In such case, pictures are
not properly projected on monitors such as TVs and
projectors.
DVD player VIDEO PROJECTOR
• When multiple components are connected to this
receiver, turn power to unused components off to
prevent interference between them.
• Disconnecting or connecting cables with the power
on can damage the equipment. Turn the power off
before disconnecting or connecting cables.
• Some DVD-Audio disks disable downmixing.
These types of disks are not played back correctly
unless the left, center, right and surround left and
right speakers, and subwoofer are connected.
• If a DVD player that does not support HDMI 1.1
is connected to the SR6001, multi channel PCM
playback is not possible even with DVD-Audio
disks.
• If an Super Audio CD player that does not support
HDMI 1.2 is connected to the receiver, DSD
playback is not possible even with Super Audio
CD.
(*DSD: Direct Stream Digital)
• If a DVD player or other device with DVI output
is connected to the SR6001, a separate audio
cable (optical-digital, coaxial digital or analog) is
needed for the audio signals. In this case, select the
connected audio input as explained in “1-1 FUNC
INPUT SETUP”. (See page 29)
• Multi channel PCM signals and audio signals of 62
kHz or higher that are input from the HDMI jack are
not output from the DIGITAL OUT jacks.
• Depending on the quiality of the cable used, the
HDMI signal may be affected by noise.
FM
(
75
)
GND AM
DC OUT
OUTPUT
COMPONENT
VIDEO
IN OUT
PRE
OUT
SLL
RSR
FLASHER
IN
SPEAKER
SYSTEMS
INPUT 1
(
DVD
)
COAX.
DIGITAL IN
DIGITAL OUT
3
54
21
SURROUND
BACK
OUT
R
OUT
L
RS-232C
OUTPUT
TAPE CD/CD-R
OUTOUTIN
MULTI
R
L
DSS
(
AUX2
)
AUDIO
TV
7.1CH
IN
IN
OPT.
DVD
(
2
)
DSS
(
4
)
TV
(
1
)
VIDEO
OUT
VCR
(
3
)
OUTIN
RC-5MULTI RC
INPUT 1
(
TV
)
INPUT 4
(
DSS
)
IN
SR
VCR
IN
INPUT 3
(
VCR
)
DVD SL
INPUT 2
(
DSS
)
ANTENNA
C
B
/
P
B
C
R
/
P
R
C
R
/
P
R
C
R
/
P
R
C
B
/
P
B
C
B
/
P
B
YYY
DVD
(
2
)
DSS
(
4
)
VCR
(
3
)
TV
(
1
)
MONI. OUT
MONITOR
OUT
SBR
SBL
SBR
SBL
C
SW
SW
C
R
L
R
R
R
L
LL
AC IN
INPUT 2
(
DVD
)
S-VIDEO
MODEL NO. SR6001
FRONT
B
SURR
OUND
CEN
TER
FRONT
A
ON
OFF
MULTI SPEAKER
/
SPEAKER C
FRONT A OR B.CENTER.SURR.
SURR BACK : 6 - 8 OHMS
FRONT A + B : 8 OHMS
HDMI
Ver1.2
UNSWITCHED
1.25A 150W
SWITCHED
1.25A 150W
AC OUTLETS
120V 60Hz
XM
HDMI OUTPUT HDMI INPUT
HDMI OUTPUT
SATELLITE TUNER