Filter
Top Products
44
Timer operation
Application section
Enter the figure of hour.
1 Enter the figure of hour.
2 Set it.
As the clock is not only used to show the time of the day but is also used in timer operations, be sure to set
the clock in advance.
2
Clock adjustment
To decrease
hour
To increase
hour
Example: Adjustment to 8:07
Activate the clock adjustment mode.
1
Press and hold for more than 2 sec, when the
power is ON.
÷ The time display starts to blink.
÷ Press the set/demo key. The hour is entered and the
minute display starts to blink.
Enter the figure of minute.
1 Enter the figure of minute.
2 Set it.
3
÷ If you make a mistake, restart from the beginning.
÷ When the time of day has been set by pressing the
set/demo key, the display shows "COMPLETE !".
÷ After a power failure or the power cord has been un-
plugged then plugged in again, it is required to set the
time again.
÷ When the 7 STOP key is pressed while the power is in
the standby mode, the time of the day will be displayed
for 5 seconds.
Example: Adjustment to 8:07
To decrease
minute
To increase
minute
menu
TIME ADJUST
volume / multi control
TIME ADJUST
set
/
demo
volume / multi control
TIME ADJUST
set
/
demo