Filter
Top Products
22
Playback of tape
Basic section
To wind tape at high speed
÷ Press the 7 STOP key to stop fast winding.
÷ The same operation is also available with the 4
and ¢ keys on the main unit.
To fast wind in
direction \
To fast wind in
direction |
Selection of TAPE equalizer (TAPE EQ.)
When playing a tape prerecorded with Noise Re-
duction system (such as the DOLBY NR) ON, be
sure to set the "TAPE EQ." ON for playback.
Each press switches the modes as follows.
1 "TAPE EQ." ON
(TAPE equalizer is used)
2 "TAPE EQ." OFF
(TAPE equalizer is not used)
Lit when "TAPE EQ." is ON
÷ Select the "TAPE EQ." ON mode according to the re-
cording condition of the tape.
To stop playback
STOP
RETURN
TUNING
Selection of reverse mode
The tape counter is set to "0000" when a cas-
sette tape is loaded. By writing down the
counter reading in case you want to interrupt
recording (playback) in the middle of the tape,
the memo will be helpful as a reference for lo-
cating the same position when continuing the
recording (playback) the next time. The tape
counter figure decrements during recording or
playback of the back side (while the 2 tape
transport indicator is lit). To set the tape counter
to "0000", open the cassette holder once. Then
the counter will be reset.
A tip for use of the tape counter
1 Select "TAPE RVS. ?".
2 Select.
3 Set it.
1 "
" : (ONE-WAY)
Only one side is played back (recorded), and then
the tape stops.
2 " " : (REVERSE)
Both sides are played back (recorded), and then
the tape stops. (When the playback direction is
"2", however, the tape stops after one side has
been played (recorded).
3 " " : (ENDLESS)
Both sides are played back endlessly. (The tape
stops after recording onto both sides.When the
playback direction is "2", however, the tape stops
after one side has been played ).
(The initial setting is "
"(REVERSE))
(Press the set/demo key while the "?" mark is
blinking)
volume / multi control
\
\
\
\
menu
set
/
demo
set
/
demo
TAPE EQ.
Main unit only