Filter
Top Products
– 34 –
Recording Any Sound Source — Standard
Recording
The following recording method can be applied to any
sound source.
1
Insert a recordable MD in the MD loading slot.
2
Select the source.
•
When recording CDs:
On the unit: Press DISC to select a disc, and press
CD # / 8, then press 7.
On the remote control: Press CD1, CD2, or CD3 to
select a disc you want to record with, then 7.
•
When recording an FM/AM broadcast:
Press FM/AM, then tune into a station you want.
•
When recording from external equipment:
Press LINE repeatedly until the external equipment
you want is selected.
When the source for recording is the equipment
connected to either the LINE 1 jacks or the LINE 2 jack,
you can select the sound input level. See “Selecting the
sound input level” on page 63.
3
Press LONG MODE on the unit if necessary.
The recording length mode changes as follows:
• For the recording length mode, see “Stereo Long-
Hour Recording (MDLP)” on page 33.
4
Press REC PAUSE on the unit (or MD REC PAUSE
on the remote control).
The REC PAUSE lamp on the unit starts flashing.
5
Press MD # / 8.
The REC PAUSE lamp stops flashing and remains lit,
and recording starts.
•
When recording an FM/AM broadcast:
The station frequency will be recorded as the track
title.
Continued
SP
(Standard Play)
LP4
(4 Times Long Play)
LP2
(2 Times Long Play)
About High-Speed Recording
There are some restrictions to observe for high-speed
recording (exceeding normal speed) to protect
copyrights. (HCMS: see page 67.)
This unit is so designed that a song (track) recorded
from a CD using high-speed recording cannot be re-
recorded until 74 minutes elapse after the previous
recording started.
If you try to re-record the same song (track) within the
74 minutes, recording is canceled and the display turns
red with “HCMS CANNOT COPY” shown as a
warning.
The remaining time required until re-recording will then
appear in the main display.
If this happens, press 7 after the remaining time
appears.
CD playback stops.
REMEMBER if you are trying to record a program
including the same song (track) twice using high-speed
recording, recording will stop at the beginning of the
2nd recording of the same song (track). (“HCMS
CANNOT COPY” will appear in the main display.)
During high-speed recording
You cannot listen to any source, and therefore, cannot adjust
the volume level. (“CANNOT LISTEN!” will appear if you try
to do.)
EN31-38.CA-MXS6MD[UJ]/f 00.11.6, 0:46 PM34