JVC CA-MXS6MD Stereo System User Manual


 
– 7 –
1
If cords are covered with insulation, twist the core of
the cord at the end of each cord, then remove the
insulation.
2 Connect the AM loop antenna to the AM LOOP
terminals as illustrated.
3 Turn the AM loop antenna until you have the best
reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered
wire to the AM EXT terminal and extend it horizontally.
(The AM loop antenna must remain connected.)
For better reception of both FM and AM
Make sure the antenna conductors do not touch any other
terminals and connecting cords.
Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
AM antenna
Vinyl-covered
wire
(not supplied)
AM loop antenna
(supplied)
Connecting Speakers
You can connect the speakers using the speaker cords.
1 If cords are covered with insulation, twist the core
of the cord at the end of each cord, then remove the
insulation.
2 Open the speaker terminal.
3 Insert the end of the speaker cord to the terminal.
Match the polarity of the speaker terminals: Red (+) to
red (+) and black (–) to black (–).
4 Close the speaker terminal on the rear of the unit.
Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
2
3
1
1
2
34
Right
speaker
Left
speaker
Black
Red
Speaker cord
Red
EN01-09.CA-MXS6MD[UJ]/f 00.11.6, 0:42 PM7