Filter
Top Products
26
CR300
<PRB1291-A>
TRACK NUMBER WRITING
1
Press the TRACK NO.
AUTO/MANUAL
button so that the
WRITE (MANUAL)
indicator lights.
2
Press the WRITE
(MANUAL) button at the
position where it is
required to renew the
track number during
recording.
• Manual writing of track number
Lights
• The WRITE (MANUAL) button is
defeated while the WRITE (MANUAL)
indicator is not lit.
• The track number can be renewed by
pressing the WRITE (MANUAL) button
when recording has elapsed for 4
seconds or more.
• Once the track number has been
written, it cannot be modified or
changed later.
Press the TRACK NO. AUTO/
MANUAL button so that the
WRITE (MANUAL) indicator
is not lit but that the AUTO
TRACK indicator lights.
• Automatic writing of track number
Goes off
Lights
• During recording, the track number is
automatically renewed by detecting
the track changes based on the input
musical signal and digital sub-code
signal.
• If the space between tracks is
extremely short, the track number may
not be advanced.
At the first, the track number automatic writing mode is selected automatically.
21
FADER
TRACK NO.
WREITE
REC
CAUTION
• Track numbers are automatically updated when the AUTO TRACK indicator is on.
• In recordings of CD, MD, DAT, DCC and other digital sources(S/P DIF only), track numbers
are automatically updated based on start-ID and / or track number included in the digital
signal information.
• AES/EBU digital signal or digital signal from media such as BS (satellite broadcasting) that
contains no track number information are recorded in the same way as analog source.
• Track numbers are automatically updated if the following signal is input after 2-seconds
of ”no signal” condition.
• In the case of digital source input, the CR300 detects the signal less than -90dB as ”no
signal”. Track numbers are automatically updated if the signal level exceeds this level.
• In the case of analog source, the CR300 detects the signal level selected by the ”Automatic
Track Number Renewal Level Sensitivity Setting” menu as ”no signal”. Track numbers are
automatically updated if the signal level exceeds this level. (See page 24.)
• Therefore recordings of classical music and other music styles with long silent passages
will be recorded on more tracks than required. Turn off the auto track function and create
new tracks manually to avoid this problem.