Filter
Top Products
18
CR300
<PRB1291-A>
5
Start playing the source player.
• This unit starts recording automatically.
• The SYNC indicator is flashing (1-track synchro recording standby), or during 1-track
synchro recording, if the input signal is interrupted or the source is switched to a source
for which auto synchro recording is not possible, the 1-track synchro recording mode will
be canceled and the unit will enter the record-pause mode.
•
I
f the SYNC indicator is not
lit after 1-
track synchro recording, the track to be
recorded next can be confirmed on the
source player.
(Automatic recording
cannot be started while the SYNC
indicator is not lit.)
SYNC indicator is not lit.
If the track changes (when input source is CD or Mini Disc), or
if the next start ID is detected (when input source is DAT or
DCC), 1-track recording will be cancelled and the unit will en-
ter the record-pause mode. The 1-track recording mode is also
cancelled if no signal (less than -90dB) condition lasts for
the length set by the MENU button functions.(See page 24)
"PMA REC" is displayed and the unit
stops after recording the track data.
AUTOMATIC DIGITAL-SOURCE SYNCHRO RECORDING
A. 1-track recording
When the source equipment starts to play, only one track is recorded automatically and the
recording stops automatically after that track. This mode is convenient for edited recording
of a CD, DAT, MD or DCC(only S/P DIF).
1
Load a CD-R or CD-RW
disc containing a record-
able space.
For a disc loading, refer to page 15.
After loading the disc, check that
the CD-R or CD-RW indicator stops
blinking and starts to light steadily.
In case it does not light steadily,
refer to page 42.
2
Set the INPUT SELECTOR
to DIGITAL.
Select OPTICAL or COAXIAL.
• The AES/EBU digital input cannot be
recorded with this function.
• The ANALOG input cannot be recorded
with this function.
3
Ensure that the source player is not playing (in stop or pause
mode).
• Confirm the track to be recorded before
recording.
Press the DIGITAL
SYNCHRO button.
Wait until the SYNC indicator blinks.
4
Blinks
• Do not start the playback of the
source player until the SYNC
indicator starts to blink.
6
• Every time the DIGITAL SYNCHRO
button is pressed, the mode is changed
in order of 1-SYNC ➔ AL-SYNC ➔
Record-pause mode.
Select "AL-SYNC" when all-track
recording is required.
Label side
• If it is required to record another track after 1-track recording, repeat steps 3 to 5 again.
After recording, press the stop ( )
button to end recording.
ANALOGDIGITAL
INPUT SELECTOR
OPT
AES /
EBU
LIN
E
COAX XLR / -10
XLR / +4
•
•
•
•
•
•
4
7
21
REPEAT
FADER
TRACK NO.
WREITE
REC
7
• Check the copy bit indicator
(refer to page 24).
• This function cannot be activated if the source is being played.