Fostex CR300 CD Player User Manual


 
19
CR300
<PRB1291-A>
5 Start playing the source player.
• This unit starts recording automatically.
When the SYNC indicator is flashing (all-track synchro recording standby), or during all-
track synchro recording, if the input signal is interrupted or the source is switched to a
source for which auto synchro recording is not possible, the all-track synchro recording
mode will be canceled and the unit will enter the record-pause mode.
After recording, press the stop ( )
button to end recording.
1
Load a CD-R or CD-
RW disc containing
a recordable space.
For a disc loading, refer to
page 15.
After loading the disc, check that
the CD-R or CD-RW indicator
stops blinking and starts to light
steadily.
In case it does not light steadily ,
refer to page 42.
2
The AES/EBU digital input cannot be
recorded with this function.
The ANALOG input cannot be recorded
with this function.
3
Ensure that the source player is not playing (in stop or pause
mode).
Confirm the track to be recorded before
recording.
Wait until the SYNC indicator blinks.
4
Blinks
Do not start the playback of the
source player until the SYNC
indicator starts to blink.
6
Every time the DIGITAL SYNCHRO
button is pressed, the mode is changed
in order of 1-SYNC AL-SYNC
Record-pause mode.
Select "AL-SYNC" when all-track
recording is required.
B. All-track recording
When the source equipment starts to play, all tracks are recorded automatically and
the recording stops automatically after the last track. This mode is convenient for
recording an entire CD, DAT, MD or DCC(only S/P DIF).
The source unit stops playback
and after no signal(less than -
90dB) condition lasts for the
length set by the MENU button
functions(see page 24), the unit
reverts to the status noted in step
4 and "AL-SYNC" is displayed
again.
Be careful not to restart playback
of the source player under this
condition, for this will start the
recording again.
Label side
CAUTION
Do not play the DAT or DCC of the source player with programmed playback, for this may lead to incorrect writing of the track numbers.
If programmed playback should be recorded, record each track separately using the 1-track recording procedure.
The track number is renewed when a start ID is detected during all-track synchro recording from DAT or DCC.
When performing all-track synchro recording from a CD or Mini Disc player using normal playback, the track number is renewed just as
the track changes on the playback side. When the CD or Mini Disc player is in the programmed playback mode, however, the track
number is not renewed until the first sound is encountered after the track changes.
"PMA REC" is displayed and the unit
stops after recording the track data.
4
6
21
REPEAT
FADER
TRACK NO.
WREITE
REC
ANALOGDIGITAL
INPUT SELECTOR
OPT
AES /
EBU
LIN
E
COAX XLR / -10
XLR / +4
Press the DIGITAL
SYNCHRO button.
Set the INPUT SELECTOR
to DIGITAL.
Select OPTICAL or COAXIAL.
Check the copy bit indicator
(refer to page 24).
This function cannot be activated if the source is being played.