Filter
Top Products
When the Mail Notification function is set to On and a problem/
warning occurs in the projector, the following e-mail is sent.
Subject: EPSON Projector
Line 1: The name of the projector where the problem has occurred
Line 2: The IP address set for the projector where the problem has
occurred.
Line 3 and on: Details of the problem
The details of the problem are listed line by line. The following table
shows the details that are given in the message for each item. To deal
with problems/warnings, see "Reading the Indicators"
s p.55
Message Cause
Auto Iris Error Auto Iris Error
Cinema filter error Cinema filter error
Cinema Filter Warning Cinema Filter Warn.
The projector can still be used but the
cinema filter does not work.
Clean Air Filter Cln. Air Filter Notice
Fan related error Fan Error
High-speed cooling in progress High Temp Warning
Internal error Internal Error
Internal temperature error High Temp Error
(Overheating)
Lamp out Lamp Error (both lamps 1/2)
Lamp replacement notification (1)
Lamp replacement notification (2)
Replace Lamp
(1) Indicates lamp 1, and (2) indicates
lamp 2. The informed lamp is due for
replacement.
Lamp timer failure Lamp Failure (both lamp 1/2)
Lamp Warning (1)
Lamp Warning (2)
Lamp Warning
(1) indicates lamp 1, and (2) indicates
lamp 2. The informed lamp is out.
Message Cause
Low Air Flow Low Air Flow
Low Air Flow Error Filter Airflow Error
No Air Filter No Air Filter/Air Flow Sensor Err.
No-signal No Signal
No Signal is input to the projector.
Check the connection status or check
that the power for the signal source is
turned on.
Peltier Device error Cooling system error (Peltier element)
Power Err. (Ballast) Power Err. (Ballast)
Power Warning. (Ballast) (1)
Power Warning. (Ballast) (2)
Supply System Warning (Ballast)
(1) indicates the lamp 1, and (2)
indicates the lamp 2. The informed
lamp is out.
Pump Error Cooling system error (pump)
Sensor error Sensor Error
Shutter Error Shutter Error
Shutter Warning Shutter Warning
Though this unit still can be used, the
electric shutter does not work.
A (+) or (-) appears at the start of the message.
(+): A projector problem has occurred
(-): A projector problem has been dealt with
Reading Problem Mail Notification Function
89