Caution
Wait until the lamps have cooled down sufficiently before removing the lamp
cover. If the lamp is still hot, burns or other injuries may result. It takes
about one hour after the power has been turned off for the lamp to be cool
enough.
Attention
•
Never use the projector unless there are two lamps installed.
•
We recommend replacing both lamps together to maintain consistent hue
and brightness of projected images.
Procedure
A
After you turn off the projector's power and the
confirmation buzzer beeps twice, disconnect the power cable.
B
Wait until the lamps have cooled down sufficiently before
removing the lamp cover on the back of the projector.
Pinch the tabs on the front of the lamp cover together to release
the lock. When the lock releases, pull the cover straight out.
C
Pull up the lock lever for the lamp you want to replace and
pull the lamp straight out.
If the lamp is cracked, replace it with a new lamp, or contact
your local dealer for further advice.
s Epson Projector Contact
List
A
Lamp 1
B
Lamp 2
D
Install the new lamp.
Insert the new lamp along the guide rail in the correct direction
so that it fits in place, push firmly until it is fully inserted, and
pull down the lock lever until it clicks into place.
Replacing Consumables
75