Filter
Top Products
Other problems
The Remote Control does not work
Check Remedy
Is the remote control light-emitting area pointing towards the
remote receiver on the projector when it is operated?
Point the remote control towards the Remote Receiver.
Operating range s Quick Start Guide
Is the remote control too far from the projector? The operating range for the remote control is about 15 m. s Quick Start Guide
Is direct sunlight or strong light from fluorescent lamps shining
onto the Remote Receiver?
Set the projector up in a location where strong light does not shine onto the remote receiver. Or set the remote
receiver to Off from Remote Receiver in the configuration menu. s Settings Menu - Remote Receiver p.45
Is the correct setting for the remote receiver selected? Check the Remote Receiver from the configuration menu. s Settings Menu - Remote Receiver p.45
Are the batteries dead or have the batteries been inserted correctly? Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary. s p.73
Are the remote control ID and the projector ID matched? Make sure the ID for the projector you want to operate and the ID for the remote control match. To operate all
projectors by remote control regardless of the ID setting, set the ID switch on the side of the remote control to Off.
s p.29
Does Remote Control Type match the remote control that you
are using?
Check the Remote Control Type on the configuration menu. s Extended Menu - Operation - Remote Control
Type p.46
Is the optional remote control cable connected to the remote
control or to the projector's remote port?
When the remote control cable is connected, the remote control light-emitting area or the projector's remote
receiver are disabled. When not using the remote control cable set, disconnect it from the remote control and the
remote port.
Nothing appears on the external monitor
Check Remedy
Are images input from a port other than the Computer or
BNC input port?
The only images that can be displayed on an external monitor are computer images from the Computer
or BNC input ports. s p.85
I want to change the language for messages and menus
Check Remedy
Change the Language setting. Adjust the Language setting from the configuration menu. s Extended Menu - Language p.46
Problem Solving
65