Filter
Top Products
When an ID is set for the projector and the remote control, you can
use the remote control to operate only the projector with a matching
ID. This is very useful when managing multiple projectors.
You can set an ID for the projector within a range of "1" to "9". The
default value is Off.
You can set an ID for the remote control within a range of "0" to "9".
The default value is "0". When the ID switch on the side of the remote
control is set to Off, you can operate all projectors by the remote
control regardless of the ID setting for the projector or the remote control.
The following table shows the possible combinations of projector ID
and remote control ID.
Opera-
tion
Combinations Descriptions
Possible
Projector ID: 1 When the control switch is
set to On, and Projector ID
matches the remote control
ID, you can operate the
projector with the remote
control.
ID switch: On
Remote control ID: 1
Possible
Projector ID: 1 When the ID switch on the
side of the remote control is
set to Off, you can operate
the projector with the
remote control regardless of
the projector's ID setting.
ID switch: Off
Remote control ID: 3
Possible
Projector ID: Off When the Projector ID is
Off, you can operate with
the remote control
regardless of the remote
control ID setting.
ID switch: On
Remote control ID: 1
Opera-
tion
Combinations Descriptions
Possible
Projector ID: 1 When the remote control ID
is "0", you can operate with
the remote control
regardless of the Projector
ID setting.
ID switch: On
Remote control ID: 0
Not possi-
ble
Projector ID: 1 When the remote control
switch is On, and Projector
ID and remote control ID do
not match, you cannot
operate with the remote
control.
ID switch: On
Remote control ID: 3
When Remote Control Type is set to Simple from Operation in the
configuration menu, you cannot set the remote control ID.
Limitation of the Number of the Target Projectors when Using Multiple Projectors
29