Filter
Top Products
Setting the Remote Control ID
Procedure
A
Set the remote control ID switch to On.
B
While holding the [ID] button, press a number button to
select a number to match the ID of the projector you want
to operate.
Once this setting has been made, the projector that can be operated by
the remote control is limited.
q
The remote control ID setting is saved in the remote control. Even
if the remote control batteries are removed to replace them and so
on, the stored ID setting is retained. However, if the batteries are
left out for a long time, it is reset to the default value (ID0).
Limitation of the Number of the Target Projectors when Using Multiple Projectors
31