Filter
Top Products
Attention
•
If an incorrect Password is entered three times in succession, the message
"The projector's operation will be locked." is displayed for about five
minutes, and then the projector switches to standby mode. If this happens,
disconnect the power plug from the electrical outlet and then reinsert it
and turn the projector's power back on. The projector displays the
Password entry screen again so that you can enter the correct Password.
•
If you have forgotten the password, make a note of the "Request Code:
xxxxx" number that appears on the screen and contact the nearest address
provided in the Support and Service Guide.
s
Epson Projector Contact
List
•
If you continue to repeat the above operation and input the wrong
Password thirty times in succession, the following message is displayed and
the projector does not accept any more Password entries. The projector's
operation will be locked. Contact Epson as described in your
documentation.
s
Epson Projector Contact List
Restricting Button Operation
The following two kinds of operation restriction functions are available
with the projector.
• Control Panel Lock
This is useful at events or shows when you want to deactivate all
buttons during projection or at schools when you want to limit
button operation.
• Lens Operation Lock
This function deactivates all buttons on the remote control related to
the lens operation to prevent improper lens adjustment after it is
properly adjusted.
Setting Control Panel Lock
Perform one of the following to lock the operation buttons on the
Control panel. Even if the control panel is locked, you can still use the
remote control as usual.
• Full Lock
All of the buttons on the Control panel are locked. You cannot
perform any operations from the Control panel, including turning the
power on or off.
• Partial Lock
All of the buttons on the Control panel, except for the [
t] button,
are locked.
Procedure
A
During projection, press the [Menu] button and select
Settings - Control Panel Lock from the configuration menu.
s "Using the Configuration Menu"
Using the Remote Control Using the Control panel
Security Functions
36