Filter
Top Products
Quick Installation Guide
7
March 2013
Step 2 continued...
Remote housing
1. Remove the transmitter head from the probe by
unscrewing the M50 nut.
For safety information regarding ESD discharge,
see the applicable warning on
page 3.
2. Mount the probe in the tank.
3. Mount the bracket to the pole, making sure the
distance between the probe and bracket does
not exceed the length of the remote connection.
Put the two U-bolts through the holes of the
bracket. Several holes are available for
vertical/horizontal pipe mounting.
Put the clamping brackets on the U-bolts and
around the pipe.
Use the supplied nuts to fasten the bracket to
the pipe.
4. Fasten the housing support to the bracket using
the M6 screws. The screws are threaded through
the top of the mounting bracket and into the
housing support.
5. Mount the probe housing on the probe, making
sure that the M50 nut is properly tightened.
6. Connect the transmitter head on the housing
support, making sure that the M50 nut is
properly tightened.
M50 nut
U-bolt Bracket Clamping
brackets
M6 screw
M50 nut