Filter
Top Products
March 2013
16
Quick Installation Guide
Configuration using the Rosemount Radar Master
software
1. Start Rosemount Radar Master (Programs > Rosemount > Rosemount Radar
Master).
2. Connect to the desired transmitter. Once the transmitter is connected, the
Guided Setup window appears automatically.
3. Click the Run Wizard for guided setup button. Follow the instructions for a
Basic Configuration and you will be guided through a short transmitter
installation procedure.
4. The first window in the Configuration Wizard presents general information
such as Device Model (5301 / 5302 / 5303), serial number, Probe Type,
Probe Length, communication protocol, and device address. Check that the
information complies with the ordering information. Click Next.
5. The General window lets you enter Tag, Message
1
, Descriptor
1
, and Date
1
.
This information is not required for operation of the transmitter and can be
left out if desired.
Handheld HART Communicator: Fast Key Sequence [2, 2, 1].
Click Next and the following window appears (Probe).
6. Verify that the parameters in the Probe window are correct. The parameters
1) Only for HART communication.
Run Wizard