Filter
Top Products
March 2013
20
Quick Installation Guide
12. The Basic Configuration with the Radar Master Wizard is now finished.
Proceed with the Device Specific Setup to see which additional configuration
is needed.
You may be required to calibrate Vapor Compensation, to set up
Probe End Projection, or to perform a Trim Near Zone depending on type of
the device, application, and functions available.
For further information, see the Rosemount 5300 Series Reference Manual
(Document No. 00809-0100-4530).
For Signal Quality Metrics information and further configuration, see the
Rosemount 5300 Series Reference Manual (Document No. 00809-0100-4530).
Setup - Modbus communication parameters
For transmitters with the Modbus option, do the following to configure the
communication parameters:
1. In the Setup menu select General. The following window appears.
2. Choose the Communication tab.
3. Click Modbus Setup.
4. Enter the desired Modbus communication settings.
Step 1: Run Wizard
Step 3: Restart the device
Step 4: View live values from the device
Step 5: Make a complete backup of the device
Step 2: Device specific setup