Filter
Top Products
PowerH SERIES
26 Owner’s Manual
CONFIG/DISPLAY SETUP/Temperature Unit: The currently
selected unit for the indication of temperature values is displayed.
Pressing the ENTER button opens the Set Temperature Unit
dialog box, which allows selecting °C (Degrees Celsius) or °F
(Degrees Fahrenheit) by pressing the Up/Down buttons. Pressing
the ENTER button stores the selected unit in memory and the
CONFIG menu reappears on the display.
Structure of the CONFIG/SERVICE menu
CONFIG/SERVICE/Restore Amplifier’s Factory Settings: The
power amplifier can be reset to factory settings. Pressing the
ENTER button opens a safety dialog box that lets the user choose
between YES or NO by pressing the Up/Down buttons. If YES has
been selected, pressing the ENTER button resets the power
amplifier to its factory settings. If the user selected NO, all power
amp parameters stay unchanged and the display returns to the
CONFIG. menu.
The following table lists all parameters that are affected by a reset:
CONFIG/SERVICE/Lifetime: This menu item shows the total
running time of the power amplifier (not counting standby times).
Parameter Value
Power-On-Delay 0.00 s
Breaker Current (depends on
the supply voltage)
16 A (230 V) / 30 A (120 V)
Amplifier Name Dynacord H2500
or
Dynacord H5000
LCD Contrast 50 %
LCD Brightness High 90 %
LCD Brightness Low 40 %
LCD Time to Dim Autodim off
Temperature Unit °C
Table 3.3: Factory settings of the LC display