Filter
Top Products
PowerH SERIES
22 Owner’s Manual
Structure of the CONFIG menu
Entering the CONFIG menu is possible through pressing the ENTER button while the entry >> CONFIG <<
is highlighted in the status display. The following provides detailed information about the individual items of
the configuration menu.
CONFIG/Power-On-Delay: The power amp’s currently set power-
on delay is shown. Pressing the ENTER-Taste button opens the
Set Power-On-Delay dialog box.
Using the Up/Down buttons in the Set Power-On-Delay lets
the user specify a delay in the range of 0 seconds to up to 6.35
seconds. Pressing the ENTER button again stores the previously
made setting and the display returns to the CONFIG menu.
CONFIG/Breaker Current: The actually set value of the current
that controls the Mains Circuit Breaker Protection is displayed.
The set current has to match the value of the power amp’s internal
fuse for the protection to work correctly. Please refer to the
explanations on page 32 for more details. Pressing the ENTER
button opens the Set Breaker Current dialog box where the
desired value for the breaker current can be set.
The valid value ranges depend on the power amp’s power supply.
Currents between 6 A and 40 A can be set when the power
amplifier is operated at 120 V. Currents between 6 A and 30 A can
be set when the power amplifier is operated at 220-240 V. Select
Factory 30 A or Factory 16 A for automatic setting
depending on the power amp’s power supply. Pressing the ENTER
button stores the selected current value in memory and the
CONFIG menu reappears on the display.
CONFIG/Show Event Log: The menu entry Show Event Log
leads to the EVENT LOG submenu. The individual entries in the
EVENT LOG menu are explained in detail in the paragraph
Structure of the CONFIG.EVENT LOG menu (see page 23).
CONFIG/Menu Display: The menu entry Menu Display leads to
the DISPLAY SETUP submenu. Each entry in the
DISPLAY SETUP menu is explained in detail in paragraph
Structure of the CONFIG/DISPLAY SETUP menu (see page 24).
NOTE:
Operating the power amplifier on a separately fused mains power line is recommended
only.