Filter
Top Products
range from 10ms – 10.0 seconds. Use the Edit/Select knob to adjust these times.
Store these changes to the preset using the Store procedure if these changes are to be
recalled later.
LFO SETTINGS
The GSP1101 has 2 programmable LFOs (Low Frequency Oscillators) per preset that
can be assigned to control parameters. The LFO will automatically control the parameter
between the minimum and maximum range as defined by the Expression Link using the LFO
waveform shape and speed set in this menu. Each LFO has three waveforms to select from
and an LFO speed range of 0.05Hz to 10.0 Hz.
To set up the LFOs
Press the Edit/Select knob twice to enter the preset edit screen.
Turn the Edit/Select knob until the LFO Settings menu is selected and press the knob.
Use the Edit/Select knob to select LFO1 Wave, LFO1 Speed, LFO2 Wave, or LFO2
Speed and press the knob to enter these menus to adjust their settings.
Store these changes to the preset using the Store procedure if these changes are to be
recalled later.
PRESET LEVEL
Each of the presets in the GSP1101 can have a specified programmed level. Preset Level is
used to balance, boost, or cut the levels between different presets.
To change the level of a preset
Press the Edit/Select knob twice to enter the preset edit screen.
Turn the Edit/Select knob until the Preset Level menu is selected and press the knob.
This will enter the Preset Level screen..
Use the Edit/Select knob to change the preset level.
Store these changes to the preset using the Store procedure if these changes are to be
recalled later.
5.
1.
2.
3.
4.
1.
2.
3.
4.
GSP0 Owner’s Manual
The Edit Effects/Preset Screen