Filter
Top Products
Press the Back button (next to the Edit/Select knob) to back out of sub-menus, and
eventually return to the preset’s main screen (thus ending the editing session). The Back
button DOES NOT cancel changes you’ve made to a preset or menu, but does cancel the
Store procedure.
Note that you must save any changes you make while editing (using the Store button), or
your changes will be lost when the GSP1101 is turned off or a new preset is selected.
Seamless Time
Presets in the GSP1101 that use delays and reverbs can have their repeats and reverb tails
heard to completion even after changing to a new preset. This is referred to as a “Seamless”
preset change. For more information, see page 41.
LFO Settings
The GSP1101 has 2 programmable LFOs (Low Frequency Oscillators) per preset that can
be assigned to automatically control parameters. The LFO will automatically control the
parameter between the minimum and maximum range as defined by the Expression Link
using the LFO waveform shape and speed set in this menu. For more information, see page
19.
Preset Level
Each of the presets in the GSP1101 can have a specified programmed level.
To change the level of a preset
Press the Edit/Select knob twice to enter the preset edit screen.
Turn the Edit/Select knob until the Preset Level menu is selected and press the knob.
Use the Edit/Select knob to change the preset level.
Store these changes to the preset using the Store procedure if these changes are to be
recalled later.
1.
2.
3.
4.
GSP0 Owner’s Manual
Using the GSP0