Filter
Top Products
Getting Started
Connections
10
ENGLISH
ENGLISH
Signal directionAudio cable
Cable indications
Connect using the connection cables shown below.
Analog connections (Stereo)
A
R
L
R
L
Pin-plug cable
System connections
B
System cable
(White)
(Red)
Connections
NOTE:
• Do not plug in the power supply cord until all connections have been completed.
• When making connections, also refer to the operating instructions of the other components.
• Be sure to connect the left and right channels properly (left with left, right with right).
• Do not bundle power supply cords together with speaker cables. Doing so could result in humming
or noise.
• Making connections with the power turned on could result in noise or damage the speakers.
• Bunching the power supply cords and connection cables together could result in humming or noise.
• Connect all the connection cables between the different components firmly. The system may not
operate properly if the connections are incomplete.
• Be sure to disconnect the power supply cords when changing the connections. Changing the
connections while the system is operating could result in malfunction.
Audio signal
IN OUT
OUT IN
CHR-F103
DRA-F102/
F102DAB
DRR-F102
Recommended system layout
To ensure performance and safety, it is recommended to arrange the components as shown below when
connecting to models in the F102 series.
NOTE:
• Arrange in such a way that the receiver’s ventilation holes are not obstructed so that the heat can
dissipate.
• Do not place other components directly on top of the receiver.
•To ensure safety, do not make stacks of more than three components.