Filter
Top Products
Remote Control Learning Mode
This remote control allows you to transfer a
command from a button on your source
remote control (original equipment remote
control) to a button on the Stargate remote
control. New commands can be taught to
any button in the CD, DVD, AUX, SAT, TV,
VCR and CBL device modes, except on the
LIGHT button.
The remote control provides distinct visual
feedback with LEDs (Light Emitting Diodes)
that are located at the top left of the remote
control (Status LED) and under the Device
buttons. The Status LED at the top left of the
remote operates in three colors (red, orange
and green). The Device buttons have a red
color LED behind them. These LEDs will
assist you in programming in the learning
section of the remote control.
Learning a New Command
Select a Device mode in which you would
like to teach the new command. For exam-
ple, if you wanted to learn a new command
to the PREV CH button in the TV mode on
the remote, you would select the TV Device
button and use the instructions below to
teach the new command to the PREV CH
button.
Step 1.
Press the Device button and the SELECT but-
ton simultaneously and hold until the orange
Status LED and the Device button turn on
and remain lit.
Step 2.
On the remote control, press the button that
is to be taught the new command. The
orange Status LED will begin to flash contin-
uously. The Device LED will turn off.
Step 3.
On the source remote control (original
remote control), press and hold the button
for the command to be learned until the
Status LED on the remote turns green.
Release the button on the source remote con-
trol.
Step 4.
Press the button on the source remote con-
trol, once again to verify that the new com-
mand has been learned correctly. The Status
LED will flash green twice and then turn to a
steady orange color indicating that the pro-
gramming was successful. The Device LED
will turn on.
Repeat Steps 2 through 4 for any other but-
tons to be taught in the Device mode select-
ed in Step 1.
Step 5.
Once you have completed learning new
commands to the buttons in the selected
Device mode you must save the pro-
grammed information. Press and hold the
Device button and SELECT button simultane-
ously and hold until the orange Status LED
flashes twice. The Device button will turn off.
Repeat the above for any other Device
modes starting from Step 1.
Page 27© 2002/2003 bel canto design, Ltd. PRePro User’s Guide rev1103