Filter
Top Products
Page 26© 2002/2003 bel canto design, Ltd. PRePro User’s Guide rev1103
POWER: Puts the PRePro into “Standby”
mode. This button cannot turn the unit on;
you must use one of the input selection but-
tons located further down on the remote (i.e.
DVD, LD, VCR1, VCR2, etc.).
MUTE: This mutes the unit.
TV: Toggles NTSC –PAL.
VOL: Volume up.
VOL: Volume down.
CH: Seek up.
CH: Seek down.
GUIDE: Press for status onscreen.
MENU: Press to get onscreen set up menu.
EXIT: Press to exit onscreen menu.
PRE CH: Turns TFT on and off.
Curser and SELECT as used in set up.
DVD, LD, VCR1, VCR2, SAT, AUX, CD, TV,
TUNER, TAPE, 7.1: Selects source and turns
unit on.
SUR: Puts unit in the surround mode to
decode any input format.
Mode: Selects Dolby Prologic movie, Dolby
Prologic 2 music,. DTS neo 6 cinema, DTS
neo6 music.
BASS: Allows you to set bass trim for each
source.
STEREO: Sets unit in the stereo mode.
MUSIC 7: Sets unit in the music 7 mode
[multi-channel mono].
1 through 10: Tuner presets.
ZONE: Zone 2 shift button. Allows remote
to control AUX, TAP, CD, TUNER, VOLUME,
SEEK, OFF, MUTE, for Zone 2.
SHIFT: Toggles the tuner between AM/FM
when the tuner source is selected.
SHIFT: In normal mode Toggles EX on and
off. If there is an EX flag on the DVD, the
shift button will have no effect.
Remote Control
Controls and Functions
The supplied remote control can operate up to
eight (8) different components and is program-
mable via a learning mode. The eight (8) but-
tons located on the top 2 rows allow you to
select the component you wish to operate.
Please refer to the next section “Remote Control
Programming” for instructions on how to manu-
ally program this remote control.
To operate the PRePro with this remote control
you must first pressthe button labeled ‘AVC’ on
the top left corner.