Filter
Top Products
Panning Frame
Assembly
Step 1
Step 2
Step 3
18
Refer to Figures 13A and 13B. Determine azimuth range requirements from APPENDIX
‘A’ (page 65) and loosely attach 200035 outrigger assembly (if required) to appropriate
side of 200031A panning assembly.
• Use 7/8 x 2-1/4 in (57 mm) hardware and apply supplied RTV to flange surfaces as
indicated.
Installation Procedures
Figure 13A
Apply supplied RTV to flange surfaces and loosely attach 200022 pivot assembly to out-
rigge as shown.
• Use 7/8 x 2-1/4 in (57 mm) hardware and apply supplied RTV to flange surfaces as
indicated
Attach 301786 azimuth pivot assembly to panning assembly as shown using 7/8 by 2-1/4
inch (57 mm) bolts and nuts. Note: Mounting hardware attaching 301786 azimuth pivot
assembly to 200031A panning assembly must be positioned as shown with resolver
mounting holes on 301786 azimuth pivot assembly positioned in downward direction.
Figure 13B