Filter
Top Products
Step 5
Step 6
16
Attach 200108 supports to 200063/200064 rear pad assemblies and 200088 joint
assembly as shown in Figure 10.
• Use 7/8 x 2-1/4 in (57 mm) bolts and nuts
•
Insert bolt from inside of joint assembly to outside of support
• Supports should be installed back-to-back with the edges forward and the flats of
angles facing rear
Installation Procedures
Attach 200873 supports between angle pairs as shown in Figure 11. Select correspond-
ing mounting holes so that 200873 supports are parallel to 200114A beam assembly.
• Use 7/8 x 2-3/4 in (70 mm) hardware
• Supports attached with edges inward and flats facing up.
Figure 11
Figure 10
20008A