Filter
Top Products
The X-Over Switch position for a 4.2ch system
(frequency range is divided between highs for front/rear and
lows for the Subwoofer).
The position of the X-Over switch: F/RISub-W
The X-Over Switch position for a 2.2ch system whose frequency
range is divided among the highs (Rear), mids (Front), and lows
(Subwoofer).
The position of the X-Over switch: 3WAV
Front high range
speaker
(l)
Rear high range
speaker
(l)
low
range
speaker
(l)
Output of this unit:
Front high range
speaker(R)
Rear high range
speaker(R)
low
range
speaker(R)
Front output
Mid range
speaker
(l)
High range
speaker
(l)
low
range
00
speaker(L)
--------
Rear output
Mid range
speaker(R)
High range
speaker(R)
low
range
speaker(R)
SUB-Woutput
• Use the Sub-Woutput cord to connect the unit to the low range speaker.
•
You
can use the built-in amplifier to output thefront output/rear output.
•
You
cannot adjust thefader when set to
3WAY:
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10
cm
away from the carharness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt
or
grease
if
necessary)
of
the car chassis.
•
If
you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise
suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
42-EN