Filter
Top Products
High Temperature
• Protective circuit
is
activated due to high temperature.
- The indication will disappear when the temperature returns to
normal operating range.
No Disc
• No CD is inserted.
- Insert a CD.
• Although a disc is inserted, "No Disc" is displayed and the unit
does not start to play or eject the disc.
- Remove the disc by following these steps:
Press the
~
button again for at least 2 seconds.
If the disc still does not eject, consult your Alpine dealer.
Error
• Mechanism error.
1)
Press the
~
button and eject the CD.
If
not ejecting, consult your Alpine dealer.
2)
When the error indication remains after ejecting, press the
~
button again.
If
the error indication still does not turn off after pressing the
~
button for a few times, consult your Alpine dealer.
• When "Error" is displayed:
If
the disc cannot be ejected bypressing
~,
press the
RESET
switch
(refer to page
7) andpress
~
again.
If
the disc still cannot be ejected, consult yourAlpine dealer.
PROTECT
I
• A copy-protected WMA file was played back.
-
You
can only play back non-copy-protected files.
I
UNSUPPORTED
I
• A sampling ratelbit rate not supported by the unit is used.
- Use a sampling ratelbit rate that is supported by the unit.
High Temperature
• Protective circuit is activated due to high temperature.
- The indication will disappear when the temperature returns to
normal operating range.
36-EN
Error
01
• Malfunction in the CD Changer.
- Consult your Alpine dealer. Press the magazine eject button and
pull out the magazine.
Check the indication. Insert the magazine again.
Ifthe magazine cannot be pulled out, consult your Alpine
dealer.
• Magazine ejection not possible.
- Press the magazine eject button.
If
the magazine does not eject,
consult your Alpine dealer.
Error 02
• A disc is left inside the CD Changer.
- Press the eject button to activate the eject function. When the
CD Changer finishes the eject function, insert an empty CD
magazine into the CD Changer to receive the disc left inside
the CD Changer.
No Magazine
• No magazine is loaded into the CD Changer.
- Insert a magazine.
No Disc
• No indicated disc.
- Choose another disc.
ANTENNA
• The XM or SIRIUS antenna is not connected to the XM or
SIRIUS radio module.
- Check whether the XM or SIRIUS antenna cable is attached
securely to the XM or SIRIUS radio module.
I UPDATING I
• Radio is being updated with latest encryption code.
- Wait until encryption code is being updated. Channels 0 and 1
should function normally.
I NO SIGNAL I (XM mode)
J ACQUIRING SIGNAL I (SIRIUS mode)
•
XM
or SIRIUS signal is too weak at the current location.
- Wait until the car reaches a location with a stronger signal.
LOADING
• Radio is acquiring audio or program information.
- Wait until the radio has received the information.