4 Connect the power cord to a properly grounded electrical outlet.
5 Turn on the scanner.
USB port [x] disabled [56]
From the scanner control panel, touch Continue to clear the message.
Notes:
• The scanner discards any data received through the USB port.
• Make sure the USB Buffer menu is not set to Disabled.
Weblink server not set up. Contact system administrator.
From the scanner control panel, touch Continue to clear the message.
Note: If the message appears again, then contact your system support person.
Solving printer problems
• “Basic printer problems” on page 309
• “Hardware and internal option problems” on page 311
• “Paper feed problems” on page 314
Basic printer problems
The printer is not responding
Action Yes No
Step 1
Make sure the printer is turned on.
Is the printer turned on?
Go to step 2. Turn on the printer.
Step 2
Check if the printer is in Sleep mode.
Is the printer in Sleep mode?
Press the Sleep button
to wake the printer
from Sleep mode.
Go to step 3.
Step 3
Check if one end of the power cord is plugged into the printer and the
other to a properly grounded electrical outlet.
Is the power cord plugged into the printer and a properly grounded
electrical outlet?
Go to step 4. Plug one end of the
power cord into the
printer and the other to
a properly grounded
electrical outlet.
Troubleshooting 309
