Close top access cover
Close the printer top access cover to clear the message.
Complex page, some data may not have printed [39]
Try one or more of the following:
• From the scanner control panel, touch Continue to ignore the message and continue printing.
• Cancel current print job.
• Install additional printer memory.
Configuration change, some held jobs were not restored [57]
Held jobs are invalidated because of the following possible changes in the scanner:
• The scanner firmware has been updated.
• The tray for the print job has been removed.
• The print job is sent from a flash drive that is no longer attached to the USB port.
• The scanner hard disk contains print jobs that were stored when the hard disk was installed in a different scanner
model.
From the scanner control panel, touch Continue to clear the message.
Defective flash detected [51]
Try one or more of the following:
• Replace the defective flash memory card.
• From the scanner control panel, touch Continue to ignore the message and continue printing.
• Cancel the current print job.
Disk full [62]
Try one or more of the following:
• From the scanner control panel, touch Continue to clear the message and continue processing.
• Delete fonts, macros, and other data stored on the scanner hard disk.
• Install a scanner hard disk with larger capacity.
Disk full, scan job canceled
Try one or more of the following:
• Touch Continue to clear the message and continue scanning.
• Delete fonts, macros, and other data stored on the scanner hard disk.
• Install a hard disk with higher capacity.
Troubleshooting 291
