Note: Held jobs that are not restored remain in the scanner hard disk and are inaccessible.
Standard network software error [54]
Try one or more of the following:
• From the scanner control panel, touch Continue to continue printing.
• Unplug the router, then wait for 30 seconds, and then plug it back again.
• Turn off the scanner and printer, and then turn back on the printer and then the scanner.
• Update the network firmware in the printer or print server. For more information, visit the Lexmark Web site at
http://support.lexmark.com.
Standard USB port disabled [56]
Try one or more of the following:
• From the scanner control panel, touch Continue to clear the message.
• Enable the USB port. From the scanner control panel, navigate to:
Network/Ports > USB Buffer > Auto
The scanner discards any data received through the USB port.
Supply needed to complete job
Do either of the following:
• Install the missing supply to complete the job.
• Cancel the current job.
Too many bins attached [58]
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra bins.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Too many disks installed [58]
1 Turn off the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the extra printer hard disks.
4 Connect the power cord to a properly grounded electrical outlet.
5 Turn the printer back on.
Troubleshooting 307
