There are three steps to set up custom paper. When all three steps are completed, the
display will return to the PAPER HANDLING menu. Once a Custom size is set for a tray, it will
be retained until the switch in the tray is moved back to Standard or you can change it in
the control panel.
1. Unit of measure
2. X dimension
3. Y dimension
1 Custom/Standard switch
Unit of measure
1. Press to highlight UNIT OF MEASURE.
2. Press
to select UNIT OF MEASURE.
3. Press
or to highlight the correct measurement.
4. Press
to select the value.
Y dimension
The Y dimension is the length of the page as it feeds into the printer.
1. Press
to highlight Y DIMENSION.
2. Press
to select Y DIMENSION.
3. Press
or to highlight the correct value.
4. Press
to select the value. If the value entered is outside the vaild range, INVALID
VALUE will appear for two seconds. The display prompts you to enter another value.
X dimension
The X dimension is the width of the page as it feeds into the printer.
1. Press
to highlight X DIMENSION.
2. Press
to select X DIMENSION.
3. Press
or to highlight the correct value.
4. Press
to select the value. If the value entered is outside the the valid range, INVALID
VALUE will appear for two seconds. The display prompts you to enter another value.
64 Chapter 4 Printing tasks EN_WW
