56 C
HAPTER
4: U
SING
THE
L
OCAL
M
ANAGEMENT
A
CCESS
Figure 51
Setting VLAN ID Message Screen.
Set Ethernet Half/Full Duplex Mode
To set Ethernet half/full duplex mode, perform the following steps:
1
In the
AP Configuration Menu
enter
2
.
2
Enter the desired mode; a confirmation message appears.
Action has been done.
Change Password
To change the password, do as follows:
1
In the
AP Configuration Menu
, enter
3.
2
You are prompted to enter the old password followed by the new
password and a confirmation, as in Figure 52
:
Figure 52
Changing Password Message
If you forget your password, contact technical support. Refer to
Appendix F
Technical Support.
Please enter your choice: 1
Note: In a topology with VCN Concentrator, this setting
may override the concentrator agent settings. For more
information please refer to the service manual.
Enter VLAN ID (1-4094, 0 for none) [none]: 2
Action has been done
Enter the old password:
Enter the new password (up to 8 characters):
Confirm new password (up to 8 characters):
The password was changed and saved in a non-volatile memory
