A SERVICE OF

logo

Open as PDF
next previous
24 C
HAPTER
3: I
NSTALLING
AND
O
PERATING
THE
VCN A
CCESS
P
OINT
5
Where the three crosshairs of the template holes intersect, indent the
surface with a sharp tool (for example a nail). See Figure 7
.
6
Remove the template.
7
Drill the indented holes with a drill bit of the same diameter as the wall
anchors. See Figure 9
.
Note: If the provided anchors are not suited to your wall, you must obtain
and insert suitable anchors that match the diameter of the provided
screws.
Figure 9
Drill Holes for Anchors
8
Insert the three anchors. See Figure 10
.