A SERVICE OF

logo

Open as PDF
next previous
Installing the VCN Access Point 23
Mounting the VCN
Access Point on a
Wall
To mount the VCN AP on a wall perform the following tasks.
1
Apply the paper template to the wall as shown in Figure 7
.
Figure 7 Using the Paper Template to Mark the Wall
The partially curved edge of the template corresponds to the curved cover
that is part of the VCN AP front panel.
2
Remove the cover by sliding it downward and then pulling it outward.
See Figure 8
.
Figure 8 Removing Curved Cover
All three holes in the VCN AP are plugged.
3
Remove the plugs from the two large holes by prying them out with the
tip of your screwdriver.
4
Remove the plug from the small hole by forcing it out from the bottom
with a pointy instrument (for example a nail).
Fax-ModemETHERNET
Line
Power
S
crew hole