VCN Access Point Menus 51
Do you want to proceed (Y/[N])? :
To c o nfi r m t y pe y; to discard, type n; and and press <Enter>.
When you proceed, the message appears:
Action has been done.
When you discard the operation, the message appears:
The action has been canceled
Setting Normal Mode
To set normal mode, type
1 and press <Enter>. The message appears:
This action will change the working mode of HDLC!
Do you want to proceed (Y/[N])? :
To c o nfi r m t y pe y; to discard, type n; and and press <Enter>.
When you proceed, the message appears:
Action has been done.
When you discard the operation, the message appears:
Normal mode is lack of loopbacks.
Reset All Counters
To reset all counters, perform the following steps:
1
In the
Main Men
u, type
3 and press <Enter>; the
Management Menu
appears.
2
In the
Management Menu
, type
4 and press <Enter>; a confirmation
message appears. The counters have been reset.
Reset the Board
To reset the VCN AP, type
5 in the
Management Menu
(Figure 32) and
press <Enter>; the messages in Figure 43
appear:
Figure 43 Reset Board Confirmation
This action will reset the whole board
Do you want to proceed (Y/[N])? :
